Technical sheet - Electric votive lamps

One of the essential elements of a tombstone is the votive lamp, so Real Votiva catalogue includes a wide range of electric votive lamps for tombstones, tombs and ossuaries, made of bronze, porcelain and steel.

Votive lamps can be mounted on vertical surface (tombstone) or on horizontal surface (horizontal shelf, tomb or monuments). Lamps are available both in simple material like bronze, black or white porcelain and steel, or in various colours, such as chromium, mercury, glitter, marble. Many models are hand decorated or embellished with bronze finish and decorations, such as roses, vines, doves and gold decorations. All lamps are equipped with crystal flame and some can mount rosebud, heart, lily or tulip shaped crystals. Most of the bronze lamps are made with die casting technique; particularly beautiful and elegant are the cemetery lamps produced with the lost wax casting and shell moulding techniques.

All lamps can be combined with photo-frames, flower vases and accessories of the same product line.

These products are covered with a special coating that ensures weatherproof and are very useful especially for outdoors planted graves.

The lamps furniture include fastening material (bolts and nuts) but not electrical equipment (electrical wiring, light bulb socket, etc.).

Votive lamps sizes

Lamps sizes range from 13 cm to 25 cm in height (H).

How to mount electric votive lamps

As mentioned above, the votive lamps can be mounted either on the wall or vertical surface (tombstone) or on level ground or floor (horizontal shelf, tombs or monuments).

Wall mounted lamps are characterized by the fact that the item code starting with the letter P, for example, P.04.1108/19; after the first letter there is the category code ("04" stands for “lamps”), then the identification code, "1108", and finally the height, i.e. "/19" indicating 19 cm.

Wall mounted lamps (P)

Wall mounting is done by two set screws (A, B) that, on one side, screws on the two spacers on the back of the lamp, while on the side of the plaque are fixed with two dice. The installation requires two holes in correspondence of the two set screws. Between the two spacers there is a hole (1) for electric wire while at the bottom of the lamp there is a small hole (2) to drain water.

Ground mounted lamps (T)

Ground mounted lamps item codes start with the letter T, for example, T.04.1108/19.

Ground mounting is done by two set screws (A, B) that screw on the base of the lamp and that are attached to the surface by two nuts. The installation requires two holes in correspondence of the two set screws. At the bottom of the lamp there is a hole (1) for electric wire and another one (2) to drain water.